IKS problem

[Simon]

Hi All,
I think a iks variable plugbar i bought recently is playing up:mad:
can anyone help with this...
the two center sockets seem to be powered up all the time :( i can only manualy adjust the % on them, the display shows them as either off or if i've set the % it displays that constantly even when its ment to be off, and whenever my Co2 solenoid clicks open all the sockets on this bar power on for a moment:confused: all my lighting flickers and flashes:(
could be why my blenny jumped out the tank:eek:

the controller and other three standard swithed plugbars all seem to be working fine,

would a system reset help or do you think the v/bar has had it:confused:

[tim_haskins]

Sounds like the plug bar has had it :( you could try to plug the bar into a diferent outlet on the iks main unit to see if anything changes.Try a system reset to see if that helps.

Tim

[tim_haskins]

Reading your post again i dont think a system reset will fix the problem:(

I think that if the socket is playing up a bad a you say ie switching all socket on when tring just to control one, Then i would recommend that you disconnect it compleatly and get it properly tested.

A dodgy plug bar could blow up equipment attached to it or worse still catch fire!

Tim