jed
03-07-07, 15:12
I have had problems with my control unit,the screen would go blank occassionally, until recently, its started doing alot more often,
i used to unplug it and reconnect it and that would sort it out.This has become alot more frequent in the last 2 weeks ,until,
it started doing it every day,then 2 days ago i reconnected it it would light up for about 5 secs then go dead again.
now i can't get anything at all,its just dead!
I'm only running temp and PH probe,and timing my lights.
I dont have it controlling temp, yet, but i'm the middle of upgrading to
a larger tank where i was going to use it to control temp and calc reactor,
now i'm worried it's not up to the job,as i have read when it cut's out like this it can leave devices stuck on.
please help,i was hoping to fit it to my new tank this week,typical..
thanks
cheers
jed :(
i used to unplug it and reconnect it and that would sort it out.This has become alot more frequent in the last 2 weeks ,until,
it started doing it every day,then 2 days ago i reconnected it it would light up for about 5 secs then go dead again.
now i can't get anything at all,its just dead!
I'm only running temp and PH probe,and timing my lights.
I dont have it controlling temp, yet, but i'm the middle of upgrading to
a larger tank where i was going to use it to control temp and calc reactor,
now i'm worried it's not up to the job,as i have read when it cut's out like this it can leave devices stuck on.
please help,i was hoping to fit it to my new tank this week,typical..
thanks
cheers
jed :(