PDA

View Full Version : Threaded pH gland

hihat
13-09-07, 18:08
Hi Steve, How easy are these to fit to a Ca reactor? Is it just a case of drill a hole in the lid and fit or do they need tapping/counter-sinking?

Cheers,

Jim.
pavlo
13-09-07, 23:21
I know the question is for Steve but I have just fitted one

I filed the thread off of my gland (ouch) and glued it into a hole drilled in the lid. It works fine.
hihat
14-09-07, 07:15
I filed the thread off of my gland (ouch)

:laugh:

Cheers Pavlo:thumbsup: ,

Jim
stevew@reefdreams
14-09-07, 19:09
You can use the ones listed on our site as above, or we will have a few leftovers from Si Garratts Calcium reactor build that have a locking nut on the back. In which case, just drill the hole and silicon and tighten the locking nut.
Steve
Lost Boys
14-09-07, 19:13
You can use the ones listed on our site as above, or we will have a few leftovers from Si Garratts Calcium reactor build that have a locking nut on the back. In which case, just drill the hole and silicon and tighten the locking nut.
Steve

Steve,

If you have any of the ones that are used on Si's can you put me down for two please.

:thanks:
hihat
15-09-07, 13:34
If you still have them I'll take one, should I order through the website?

Cheers,

Jim:thumbsup:
hihat
26-09-07, 22:21
Hi Steve, do you still have any of these left and should I order it as one of the normal ones off the site:) .

Jim