M1ST
22-08-08, 18:52
Hi Guys,
I picked up a couple of Wireless wave drivers from STM on Wed while you guys were there :)
One of the wave drivers is showing incorrect colour readings i.e. when it's supposed to show orange it shows purple, so I'm not sure what its doing half the time.
Occasionally it will show the correct colours but for about 10 seconds after which it just starts showing wrong colours again. Is there a fix for this or will this have to be replaced?
(I should add these are Gen1 and not been upgraded to Gen2 yet, perhaps upgrading it might cure the problem?)
Thanks!
Naum.
I picked up a couple of Wireless wave drivers from STM on Wed while you guys were there :)
One of the wave drivers is showing incorrect colour readings i.e. when it's supposed to show orange it shows purple, so I'm not sure what its doing half the time.
Occasionally it will show the correct colours but for about 10 seconds after which it just starts showing wrong colours again. Is there a fix for this or will this have to be replaced?
(I should add these are Gen1 and not been upgraded to Gen2 yet, perhaps upgrading it might cure the problem?)
Thanks!
Naum.