stevew@reefdreams
18-09-08, 21:47
A new firmware has been released and can be downloaded from here:
http://www.ghl-kl.de/Produkte/Aquaristik/Download/AllProfiLuxII_V403.zip
and the Control Software from here:
http://www.ghl-kl.de/Produkte/Aquaristik/Download/ProfiLuxControl_II_V4030.exe
and the manual from here:
http://www.ghl-kl.de/Produkte/Aquaristik/Download/Manual_ProfiLuxII_V403.pdf
New in this release:
1. Temperature deviation for 1-10v control, this means you can set the deviation from required temperature for 1-10v controlled heating and cooling devices. So if you set the deviation at 2C then the fans or PTC will be running at full speed when the temp is 2C above the required temperature. At 1C above the required temp the fans will be running at 1/2 speed etc.
2. Automatic water change now possible with just 2 level sensors - a much asked for feature!
Situation:
Level sensor 1 for ATO and refilling water (AWC)
Level sensor 2 for draining water during AWC
Problem:
Solenoid 1 should be used for ATO, but solenoid 2 for AWC
The socket with function "water 1" will be on in both cases
Solution:
Use the new socket function "Water change" (from firmware 4.03 on)
Define logic 1: Water 1 AND Water change
Define logic 2: Water 1 AND [Inverse] Water change
Then assign functions "logic 1" and "logic 2" to 2 sockets
Result:
One socket will be active during normal operation (ATO), the other one during AWC
3. Density - There is now an offset available for density calibration, so that you can fine tune the calibration.
Steve.
http://www.ghl-kl.de/Produkte/Aquaristik/Download/AllProfiLuxII_V403.zip
and the Control Software from here:
http://www.ghl-kl.de/Produkte/Aquaristik/Download/ProfiLuxControl_II_V4030.exe
and the manual from here:
http://www.ghl-kl.de/Produkte/Aquaristik/Download/Manual_ProfiLuxII_V403.pdf
New in this release:
1. Temperature deviation for 1-10v control, this means you can set the deviation from required temperature for 1-10v controlled heating and cooling devices. So if you set the deviation at 2C then the fans or PTC will be running at full speed when the temp is 2C above the required temperature. At 1C above the required temp the fans will be running at 1/2 speed etc.
2. Automatic water change now possible with just 2 level sensors - a much asked for feature!
Situation:
Level sensor 1 for ATO and refilling water (AWC)
Level sensor 2 for draining water during AWC
Problem:
Solenoid 1 should be used for ATO, but solenoid 2 for AWC
The socket with function "water 1" will be on in both cases
Solution:
Use the new socket function "Water change" (from firmware 4.03 on)
Define logic 1: Water 1 AND Water change
Define logic 2: Water 1 AND [Inverse] Water change
Then assign functions "logic 1" and "logic 2" to 2 sockets
Result:
One socket will be active during normal operation (ATO), the other one during AWC
3. Density - There is now an offset available for density calibration, so that you can fine tune the calibration.
Steve.