1-10V settings for LEDs

[instantsquid]

The manual says that for GHL LED units the 1-10V settings should be be set to 0.8V

However the application asks for minimum and maximum values, the latter of which cannot be lower than 6.

Any ideas?

[craigg]

My Storm sticks are on 1 min and 10 max

Only did I change my stream controls to 3 min and 8 max.

[SCOOB]

my led blocks are 0-10 i believe too.

[gregg]

and mine

[instantsquid]

So the manual is talking ess-aitch-one-tea? :confused:

[stevew@reefdreams]

I beleive this to do with the minimum voltage at which the LED's operate. In order to to get a full 100% dimming then the settings should be 0.8v to 10v as the LEDs won't be on below 0.8v.
I am sure the difference in illumination is minimal so 0-10v and 1-10v will work.

Steve

[Rental]

Interesting - I have never read the manual concerning the LEDs. I did notice my LEDs strobe the other day though when they had just come on (very dim). Maybe that is why there is a minimum setting.

Might change mine.

[instantsquid]

Cool - cheers for that, Steve :)