Cant get it up!

[fishmaduds]

Hi

(Pardon the pun!)........Try as I might, I am really struggling to create any kind of wave with my newly purchased MP40w's.............If your ever in the Birmingham area, and fancy a big cup of tea...would you help me out?

Warmest Regards

Mark

[the garden flat]

get it on the blue mode constant, then i think hold set it will start flashing then turn the power up / or down until you achieve your desired wave

hth

p.s. as much as I woudl love a LARGE cup of tea birmingham is a little too far to travel, besides its likely it'll be cold by the time I can get there

[instantsquid]

You said "MP40s" so I'm assuming you've got a pair? Are they configured as master and slave?

[the garden flat]

well read missed that, even easier in that case!

[cdurkin100]

As instantsquid said. You need two IMO to create the wave effect. One just wont do it.

[fishmaduds]

yep I have 2...and Ive done evrything thats been said...but still no wave!

[porter_painter]

are they near the top of the tank?

[dan2009]

ive seen these things work quite a way under the surface and still put out a nice wave, wish i could offer help here mark, but i will watch this thread incase i 'aquire' any problems when i eventually get mine

[adamgreen240]

Hi, i have 2 X MP40Ws

Have you configured them as master and slave?

And then do you have the slave in 'antisync' mode? represented by an Orange LED?

As said above, near the surface (i have mine about 6 inches down) , then blue mode...

Adam

[fishmaduds]

adamgreen240........how do you get the slave into antisync mode?

[adamgreen240]

press the mode button on the slave...

SHould change from White (sync)
to Orange (antisync)