How do you set up antisync mode?

[fishmaduds]

Hi

I have 2 MP40w's (2nd Generation).........I would like to set the up so the slave unit goes into antisync.Ive read the manual, and it mentions that this can be done, but its not clear/it does not explaine how its done.........ANYONE!???

[MATT2504]

http://ecotechmarine.com/customer-service/how-to-videos/
i am no geek but will this help?

[rattters]

Press and hold both buttons on one driver, the light will flash red, white & blue.

Press and hold the dark grey button, the lights will flash red & purple.

Press the light grey button.

Repeat this (1-3) on the other driver unit.

Press and hold both buttons on one driver, the light will flash red, white & blue.

Press and hold both buttons on the other driver, the light will flash red, white & blue.

Decide which pump is to be the master and press (short press) the dark grey button on the driver until the lights flash blue and green.

Press (short press) the light grey button on the other driver and the lights will
flash blue & yellow

Now hold the dark grey button on the master driver and that should be that


HTH:)

[fishmaduds]

ratters...........many thanks for responding, however the info only teels me how to set up the master & slave which is in the manula.it still does not give me how I get teh slave pump to be in antisync mode

[rattters]

ratters...........many thanks for responding, however the info only teels me how to set up the master & slave which is in the manula.it still does not give me how I get teh slave pump to be in antisync mode

Press the mode button on the slave driver, you will then get either a orange light for anti sync or blue for sync mode.
By keep pressing it you can switch between the two.

Let me know if it works:)