stevew@reefdreams
14-07-09, 20:10
There is a new beta version of the software and firmware.
This version now includes:
- Support for card PLM-ADIN (universal analog and digital inputs)
- Simulation of moon phase, clouds, thunderstorm and rainy days can be activated for each illumination channel separately
- Current simulation: Random wave duration possible
- Thunderstorm simulation: Random starts of thunderstorms can be activated
- New menu structure in ProfiLux, all settings for probes are now centralized in "sensor settings"
- Virtual probes: average calculation and monitoring of the deviation of 2 probes of the same type is possible now
- ProfiLux View: only the used switchable sockets are displayed
- Intensity of 1-10V output based on air temperature adjustableThis is Beta software so you should only upgrade if you wish to test this software and can accept changes that might be necessary.
Remember before you upgrade back up your settings and sensor data from Profilux > PC. Remember that it might look like your settings are still there as the descriptions for sensors and functions are stored on your PC not on the profilux, so it is advisable to load all your settings and sensor data back into the profilux after the upgrade.
The correct sequence is to download the firmware, and then upgrade your profilux with the new firmware using your current software version, then remove your old version of the profilux control software and install the new version. Then connect and restore your settings and sensor data.
Steve
This version now includes:
- Support for card PLM-ADIN (universal analog and digital inputs)
- Simulation of moon phase, clouds, thunderstorm and rainy days can be activated for each illumination channel separately
- Current simulation: Random wave duration possible
- Thunderstorm simulation: Random starts of thunderstorms can be activated
- New menu structure in ProfiLux, all settings for probes are now centralized in "sensor settings"
- Virtual probes: average calculation and monitoring of the deviation of 2 probes of the same type is possible now
- ProfiLux View: only the used switchable sockets are displayed
- Intensity of 1-10V output based on air temperature adjustableThis is Beta software so you should only upgrade if you wish to test this software and can accept changes that might be necessary.
Remember before you upgrade back up your settings and sensor data from Profilux > PC. Remember that it might look like your settings are still there as the descriptions for sensors and functions are stored on your PC not on the profilux, so it is advisable to load all your settings and sensor data back into the profilux after the upgrade.
The correct sequence is to download the firmware, and then upgrade your profilux with the new firmware using your current software version, then remove your old version of the profilux control software and install the new version. Then connect and restore your settings and sensor data.
Steve