mp40w red light

[mjfaderway]

hi
come home to find that one of my pumps is flashing red
what can i do to fix this?

[Bobg]

Have a look on ecotech website they have all the different light combinations and what to do
Cheers Bob

[mjfaderway]

ok ive done the below still no good any ideas
If your pump is blinking red (excluding older non-WWD MP40 pumps), this is likely because the auto-shutoff calibration sequence was entered while the pump was attached to the aquarium. To cancel this calibration, perform the following sequence:

1. Hold mode (pump blinks white)
2. Hold mode and set (pump blinks yellow/white)
3. Cycle power to the pump by un-plugging and re-plugging it in

The pump should start back up and run normally.

[rattters]

There have been issues with the bearing swelling up and causing the pumps to seize, drop Jez a PM, he should be able to help:)

[mjfaderway]

Ok will do cheers

[mjfaderway]

just pluged it back in to see if i have any luck now its smoking :eek::annoyed: