PDA

View Full Version : MP40W stalling and turning off

joe dredd
24-12-09, 15:48
Jez

Can you help, I have replaced the wet side twice and done the config twice and yet my MP40W still keeps turning itself off. Can you please pm your address so I can send it to you for repairs/ replacement of defected parts.

Thanks
George
Cav
24-12-09, 16:10
How long was it after you changed the wet side did it start to happen again? I had a similar problem and Jez sent me the replacement bearing/prop etc and it solved the problem.
rattters
24-12-09, 16:12
To get you through the Xmas period if it is the bearing issue then you can put the bearings in the oven on 200 deg c for an hour to 'dry' them out.
Cav
24-12-09, 16:24
To get you through the Xmas period if it is the bearing issue then you can put the bearings in the oven on 200 deg c for an hour to 'dry' them out.

Could I do that with my old one then or will the fact I have had it out of water for a couple of weeks mean it would be ok to use now?
rattters
24-12-09, 16:29
Could I do that with my old one then or will the fact I have had it out of water for a couple of weeks mean it would be ok to use now?

It wouldn't hurt to stick it in with the turkey (save on the gas/leccy) and dry it out thoroughly as a spare. :D
Cav
24-12-09, 18:06
It wouldn't hurt to stick it in with the turkey (save on the gas/leccy) and dry it out thoroughly as a spare. :D

Not sure the mother in law would approve :laugh:
jez
24-12-09, 23:04
HI
As you are local we can sort this quickly via one of the Kent LFS

let me know which one you use.

regards Jez