![]() |
|
|||||||
| DIY For your DIY plans, ideas, and related info. |
![]() |
|
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
|
Jewul T8 conversion to T5's
Hi all Pants selection of pics really, didnt think of it to much but should have took more pics, but some breif instructions on how to turn Juwel T8's into a T5 unit. Fist rip out the old holders and ballast, i then blanked off the old holes with some black plactic, glued then siliconed to stop water ingress, after i used the Arcadia T5 holders that can be bought seperatly at around £8 for one tube, put a light tube into the holders and marked where i needed to drill the holes, drilled then fixed the brackets in place and fed wires into the central columb and sealed all holes, fixed the new T5 Osram Ballast in place, wired up the lights and sealed the whole unit back up again. Then added some Arcadia reflectors to the tubes to boost the light from them. HTH and its not to vauge for you :-
![]() ![]() ![]() ![]() Rich |
|
#2
|
||||
|
||||
|
this will help alot of people who are converting jewel tanks over, if i had of seen this last week i would of done this over the crazy plan ive got going ( all parts orders so no turnning back)
|
|
#3
|
||||
|
||||
|
I shall being doing mine at some point, so will get some more pics hopefully to help out.
|
|
#4
|
||||
|
||||
|
Another option would be to use GHL end caps which are the same as the Juwel ones, but obviously for T5 tubes. They are about £10/4.
__________________
Alan "Not using a quarantine tank is like playing Russian roulette. Nobody wins the game, some people just get to play longer than others." - Anthony Calfo |
|
#5
|
||||
|
||||
|
The principal is the same for any end caps, the only diffrence is the way they are fixed to the unit same goes for the ballast really HTH
|
|
#6
|
||||
|
||||
|
hi there where do you get the parts from very keen to convert, great job by the way
__________________
Tank: 300L bow front, MW t5, 2x t8 MB, Nitratreductor NR 1000, Phosban150, TMC V2 Vecton 200 and V2 1000 skimmer. |
|
#7
|
||||
|
||||
|
Any good LFS should be able to supply the parts, arcadia end caps, and a osram t5 ballast, if not im sure you can find them on the tinternet
HTH |
|
#8
|
||||
|
||||
|
thanks found some on flebay
__________________
Tank: 300L bow front, MW t5, 2x t8 MB, Nitratreductor NR 1000, Phosban150, TMC V2 Vecton 200 and V2 1000 skimmer. |
|
#9
|
|||
|
|||
|
Hello.Exellent idea.Gonna give it a try,I have a Jewel vision 450.It has 4 t8 bulbs.
What size of ballast do i need for t5 bulbs around 4ft. ? i think they are 46inch Do i need a 2x54w ballast to run 2 bulbs ? or better to buy 2 single ballasts? Thanks.You make it sound so easy.LOL Cheers Spike |
|
#10
|
||||
|
||||
|
i got 3 intelligent double ballasts from ebay around £12 each will do all 3 arcadia sizes of tube
kev |
![]() |
| Thread Tools | |
| Display Modes | |
|
|